rasband said:
In a car it'll deform a good bit (maybe not a jeep). I am surprised your license plate bracket held up, how was the color on it?

For my BMB taillight housings I have some ASA-CF to print those in

Color was fine. It did start getting brittle before it was removed, pressure on the bolted connection that I should have made thicker. I printed as PLA as a test run with intent to print in ASA but it held up fine so I left it. Sat outside all summer and was in the storage unit all winter, got down to -20 there.

Was printed on my ender 3.

The new mount in ASA, printed on the bambu and using the dovetail connection to get the size. No idea if I could do that on the Ender but it was easy on the Bambu. Light wiring ran through both brackets.

Side note I print a lot of templates with the printer. For example in order to position the plate I made a template that picked up the top two bolt holes in the tailgate armor, bolted it on and then had holes for center punching where the plate bracket holes go. No tape measure used.

Spare Tire Carrier Drill Template

Exterior Light Mount Bracket (PLA/ASA)

Often appears with