The whole center console is kind of getting revamped. The nutcerts in the floor that hold the back of the console started to spin so I had to drill them out and replace them, and had to use a much larger nutcert to fill the hole left in the floor. Also, getting the nuts out mangled the rear cup holder, so I had to fix that with a printed part that I used epoxy to attach to the bottom of the console. The metal bracket for the sub is not strictly necessary for me since I removed it, but I figure I may use it at some point, so I modeled the repair to include it. With the larger bolt sticking up more into the cup holder area I also had to replace the little rubber base of the cup-holder to allow more clearance for the screw head.